TI-BASIC:Basic Graphing

From Learn @ Cemetech
Jump to navigationJump to search

Setting up your Graph screen

Using the window button you can acces the window menu. In this menu you can read the following:

  1. Xmin
  2. Xmax
  3. Xscl
  4. Ymin
  5. Ymax
  6. Yscl
  7. Xres

Xmin


This is the value on which the calculator starts the X-axis of the graph (the minimum value a X coordinate can have). For instance, you need the X-axis to go from -2 till 10. In that case you would enter -2 here note: You must use the (-) button instead of the - button, the (-) button declares a negative value whilst the - button declares to subtract value A from value B.

Xmax


This is the value on which te calculator Ends the X-axis of the graph (the maximum value a X coordinate can have). For instance, you need the X-axis to go from -2 till 10. In that case you would enter 10 here.

Xscl


This is the value on which te calculator Draws a point along the X-axis of the graph. For instance, you need a point after each 5 values in that case you would enter 5 here

Ymin


This is the value on which the calculator starts the Y-axis of the graph (the minimum value a Y coordinate can have). For instance, you need the Y-axis to go from -2 till 10. In that case you would enter -2 here note: You must use the (-) button instead of the - button, the (-) button declares a negative value whilst the - button declares to subtract value A from value B.

Ymax


This is the value on which te calculator Ends the Y-axis of the graph (the maximum value a Y coordinate can have). For instance, you need the Y-axis to go from -2 till 10. In that case you would enter 10 here

Yscl


This is the value on which te calculator Draws a point along the Y-axis of the graph. For instance, you need a point after each 5 values in that case you would enter 5 here

Xres


Needs to be edited

== Graphscreen ==