TI-BASIC:Polar Mode

Command Summary

Enables polar graphing mode.

Command Syntax

Polar

While editing a program, press:

1. MODE to access the mode menu.
2. Use arrows to select Pol.

TI-83/84/+/SE

1 byte

The Polar command enables the polar graphing mode.

Unlike the previous modes, polar mode doesn't use the more common (x,y) coordinates. Instead, the coordinates (r,θ) are used, where θ is the counterclockwise angle made with the positive x-axis, and r is the distance away from the origin (the point (0,0)). Although it's possible to translate from one system to the other, polar coordinates are more useful for some expressions (and, of course, less useful for others).

In particular, they're very good at graphing anything circle-related. The equation for a circle in polar mode is just r=1 (or any other number, for a circle of different radius).

Like in parametric mode, the parameter θ uses the window variables θmin, θmax, and θstep to determine which points are graphed. A common situation is θmin=0, θmax=2π: in Radian mode, this corresponds to going all the way around the circle. Of course, you could use Degree mode and set θmax to be 360, but this is uncommon in mathematics.

The window variables that apply to polar mode are:

• θmin -- Determines the minimum θ-value graphed for equations.
• θmax -- Determines the maximum θ-value graphed for equations.
• θstep -- Determines the difference between consecutive θ-values.
• Xmin -- Determines the minimum X-value shown on the screen.
• Xmax -- Determines the maximum X-value shown on the screen.
• Xscl -- Determines the horizontal space between marks on the X-axis in AxesOn mode or dots in GridOn mode.
• Ymin -- Determines the minimum Y-value shown on the screen.
• Ymax -- Determines the maximum Y-value shown on the screen.
• Yscl -- Determines the vertical space between marks on the Y-axis in AxesOn mode or dots in GridOn mode.