TI-BASIC:Log

From Learn @ Cemetech
Revision as of 15:17, 24 February 2016 by KermMartian (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigationJump to search

LOG.GIF

Command Summary

Computes the (principal branch of the) base 10 logarithm.

Command Syntax

log(value)

Menu Location

Press the LOG key to paste log(.

Calculator Compatibility

TI-83/84/+/SE

Token Size

1 byte

The log( command computes the base 10 logarithm of a value -- the exponent to which 10 must be raised, to get that value. This makes it the inverse of the 10^( command.

log( is a real number for all positive real values. For negative numbers, log( is an imaginary number (so taking log( of a negative number will cause ERR:NONREAL ANS to be thrown in Real mode), and of course it's a complex number for complex values. log( is not defined at 0, even if you're in a complex mode.

Advanced Uses

Using either the Ln( or the log( command, logarithms of any base can be calculated, using the identity: <math> \log_b{x} = \frac{\ln{x}}{\ln{b}} = \frac{\log{x}}{\log{b}} </math>

So, to take the base B log of a number X, you could use either of the following equivalent ways:

:log(X)/log(B)
:ln(X)/ln(B)

This is the exponent to which B must be raised, to get X.

The base 10 logarithm specifically can be used to calculate the number of digits a whole number has:


:1+int(log(N))


This will return the number of digits N has, if N is a whole number. If N is a decimal, it will ignore the decimal digits of N.

Error Conditions

Related Commands